Ford Mustang Forum banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
55 Posts
Discussion Starter #1
what do i have to do to fit a 93 5.0 T5 into a 95 5.0 ? i know it is posible, i need help from you guys. i have some mechanic experience, just not with Mustang. thanx alot guys.
 

·
Registered
Joined
·
355 Posts
i wanna say you swap input shafts and bellhousings.

someone should know though..im not 100% sure
 

·
Registered
Joined
·
55 Posts
Discussion Starter #3
okie, so the length of input shaft in a 93 is 7.18" and the one out of the 95 is 7.85, i can swap the shaft over. now i'll have to look for a bell housing, maybe dealer right ? because even if find a tranny, there won't be a bell housing with it either. Is there a "wanted ad" section in this forum ? i'm newbee to this.
 

·
Registered
Joined
·
355 Posts
okie, so the length of input shaft in a 93 is 7.18" and the one out of the 95 is 7.85, i can swap the shaft over. now i'll have to look for a bell housing, maybe dealer right ? because even if find a tranny, there won't be a bell housing with it either. Is there a "wanted ad" section in this forum ? i'm newbee to this.
dealers double the price on everything.

used ones are perfertly fine..look on craigslist..local junk yards..ustang classifieds etc..you should find a good used one for arounf $50 to $100..new around $200 from summit.

i think theres a wanted ad place here..not sure
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top