Ford Mustang Forum banner

T5 Swap dust sheild question

871 Views 1 Reply 2 Participants Last post by  66 restomod
Im doing the T5 swap in my 67 (with a 302) which came from the factory with a manual transmission. It currently has a later model C4. The dust shield between the bellhousing and the block doesn't cover the bottom of the bellhousing and the flex plate is visible. I assume its from the original transmission.

The question is, do I need some other dust shield for my late model bellhousing that is going in in with the Swap?

The follow up question is where do I find one? Or is it just as easy to make one out of sheet metal? If that is the case, is there anything fancy I need to do other than cut a hole for the starter.

Thanks in advance.
1 - 1 of 2 Posts
I found mine on Ebay for $29 new. It matched up the T5 belhousing to the 289. It was a universal one for 289/302.
1 - 1 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.