Ford Mustang Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
56 Posts
Discussion Starter #1
I am converting the suspension in my 1966 Coupe to 5 lug, it originally was a 6 cylinder. I am putting an 8" Ford rearend in it. Does anybody know what, color the rearends were in 1966? Or were they just plain black? What about the engine block for 6cyl in 1966?
 

·
Registered
Joined
·
9,200 Posts
Hello.:) The axle housing was black, the center section was red oxide primer and the nuts and studs were natural. There were also some small sextions around the center section that were natural. Here's a picture of what an 8 inch rear end should look like. The red oxide has been freshened up a bit, but, other than that, it has just been cleaned up. :)
 

Attachments

1 - 2 of 2 Posts
Status
Not open for further replies.
Top