They finally finished the Stroker Stang on Horsepower

1284 Views 6 Replies 5 Participants Last post by BKid, May 4, 2008

bigwilly43729

Discussion Starter · May 3, 2008

Anyone who watches the show Horsepower knows about the Stroker Stang they put together awhile back, but they never showed us the finished product. Well, I'm watching it now and they finally finished it. They had some cam phaser issues with the more aggressive cam which is why it took so long. It has the basic bolt-ons that we all know and love, plus p/p heads and COMP Cams (I don't know what stage). I'm assuming the gear ratio was stock. They pumped out 378rwhp and 374 ft/lbs of torque. I don't think that was with tuning either. So you guys who are shooting for 400hp NA, it's not that far off for you. It'll just cost a few bucks.

Save

Status: Not open for further replies.

1 - 3 of 7 Posts

bigwilly43729

Discussion Starter · #5 · May 4, 2008

stlwagon said:
I'm guessing that it didn't include the other basic boltons yet (CAI, headers, plates etc)?

Oh no, it had just about everything they could throw at it. From what I remember it had a C&L intake, BBK LT's w/catted X, Magnapacks, new clutch. They didn't do delete plates or UDP's and I don't think they did any tuning either. I'd be curious to see what they could get out of a dyno tune and those extra mods.

Save

bigwilly43729

Discussion Starter · #6 · May 4, 2008

hotshot said:
they could have made a really short show and slapped on a S/C and made those numbers, but then again it would not of been nearly as much fun as modding all the different parts of the car

They did a Roush S/C on another show. It's amazing that they could get that done in only 30 min! :nogrinner

Save

1 - 3 of 7 Posts

Status: Not open for further replies.

Top Contributors this Month