Ford Mustang Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

· Registered
Joined
·
371 Posts
Discussion Starter · #1 ·
Hey guys.Just got done w/ rebuilding the lower half of my 306 & used a beam style torque wrench to turn the crank & w/the cam hooked up it takes approx 30 lbs to keep it spinning.Do you guys think this is acceptible?Does this tell me a lot about my engine.All specs were .002 clearance.thanks.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top