Ford Mustang Forum banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter #1
im putting together a 5.0L with carburator. im using the two piece eccentric with the short dowel pin. should the rear piece of the two piece eccentric be loose. mine is about 1/16 inch away from the cam gear and can turn freely. the middle piece is tight. just doesnt seem right but is it?
 

·
Registered
Joined
·
46,020 Posts
That doesn't sound right to me either. Are you sure about those two parts he mentioned?
 

·
Registered
Joined
·
176 Posts
Okay then... there you go.
I can tell you, my EFI eccentric did not spin freely when I took it off. I am now carbed so this does not affect me.

Good luck with your build, post up if you learn anything else about this subject.
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top