Ford Mustang Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter #1
I have the UMI LCA relocation brackets set on the upper hole and I just put in the Strano rear bar. I can only set the bar to the softest setting as trying to go stiffer causes the bar to hit the mounting bolt/nut on the LCA. Is there any way around this? I do not want to lower the LCA's to the lower hole on the brackets since my LCA's are already perfectly parallel now.
 

·
Registered
Joined
·
459 Posts
I have the UMI LCA relocation brackets set on the upper hole and I just put in the Strano rear bar. I can only set the bar to the softest setting as trying to go stiffer causes the bar to hit the mounting bolt/nut on the LCA. Is there any way around this? I do not want to lower the LCA's to the lower hole on the brackets since my LCA's are already perfectly parallel now.
Did you ever figure this out?
 
1 - 2 of 2 Posts
Top