Ford Mustang Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
914 Posts
Discussion Starter #1
In the instructions for installing my steeda upper control arm it says that I should disconnect the mount that holds the control arm to the underside of the car but I cannot find the torque specs on the bolts that hold it to the car so has anyone else done this install? If so what did you do? and what are the torque specs on the bolts?
 

·
Shelby Gt 350 member
Joined
·
9,239 Posts
I use the German torque specs.

Blue LocTite and set your wrench at goodantighten:bigthumbsup
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top