UPR Billet AC control knob issue

1211 Views 13 Replies 8 Participants Last post by JetBlack, Jan 31, 2006

vistapony

Discussion Starter · Jan 30, 2006

I just recieved the set of UPR temp control knobs right before lunch. So I run out to my car to make the switch. They look good and fit well until I started turning the temp knob and the fan location selection know (middle and right). They just spin all the way around. I don't like it at all. The factory knobs have a raised area on the back of the knob that contacts an inner ring on each dial to provide a positive stop in both directions. I just wrote UPR and asked them is this is by design and if so I don't like it. Anyone else have UPR knobs and notice this or is it just mine? I know Rygen just got some of these if I remember right. I got the pure round ones that match the shape of the radio button. Part number 1003-05-5 :sosad:

Save

Status: Not open for further replies.

1 - 1 of 14 Posts

005 GT

· #5 · Jan 30, 2006

I had the same problem with my round ones. I took em off and put the stock ones back on. But now will try what woodj said. maybe can get them to work. Thanks woodj...... BTW woodj.....did that rear spoiler of yours cover the stock spoiler holes or did you get the spoiler delete? I like the spoiler....but got holes to cover.

Save

1 - 1 of 14 Posts

Status: Not open for further replies.

Top Contributors this Month