Ford Mustang Forum banner

V-Sixer Monte Carlo bar

1443 Views 13 Replies 7 Participants Last post by  Dineau
Googled this up last weekend, got a hit for a guy on Ebay, made the bid (50 bones!) and got the part yesterday. Will post pix later today. Fit right over the inside bolts of the strut towers, about perfectly. One curious (hopefully not problematic) issue: The hood didn't want to shut for about the first ten times I tried, after the install. Near as could tell, the hood insulation was not "giving" with the new bar in place. I let the hood rest against it for about ten minutes while pondering, and then it closed on the next try. The fit appears very snug in there, but am gonna give it a road test this morning and make sure there's nothing to worry about.

Looks like the guy is selling more of 'em here:

Comments/criticisms welcomed...
1 - 3 of 14 Posts
That's not too bad. Is it putting any pressure on the hood or did it just compress the insulation?
Hoodlum said:
Steeda makes one(not listed on there site) but has it listed on there site(made a post the other day) direct link

Just incase you didnt know.
You can pick up that Steeda STB for $159.99 at Brenspeed.
Hoodlum said:
military discount at stangsuspension not listed :cool: But thanx for another site to peruze!

EDIT: Just checked out Brenspeed they dont carry the V6 version(GT version does not fit V6). So stangsuspension is the only site I've seen so far that does.
Sorry... My bad.
1 - 3 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.