Ford Mustang Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
This might seem a little crazy, but I have been considering swapping my v-6 motor out for a 5.0. The only reason is because I have roughly 6grand in my body work. And I dont want to trade my v-6 stang for a gt and loose all my $ and hard work on the body of my v-6, and have to start from scratch again... What exactly would it take for me to put 5.0 in my v-6? What all would I have to switch out, and about what would it cost? Anyone have a clue??? Thanks
 

·
Registered
Joined
·
623 Posts
unless its a foxbody mustang please just save yourself the headache and trade your car for a GT.. there is too much involved in doing the swap.. motor, wiring harnesses, rear end, ect.. like i said save yourself the trouble and just buy a GT
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #4 ·
Its a 2001 mustang 3.8 liter. I will have to get some pics of my car on here, and after you see them you will understand why I hate to get rid of it. I was looking into a 99-04 mustang gt. I am looking for something wrecked, with low miles. What do you think??
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top