Ford Mustang Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
50 Posts
Discussion Starter · #1 ·
I just swapped the motor and tranny out of a 95 Mustang that had a V6 and put in a carberated V8. I also swapped out the AOD tranny with a C4 and have found that the tranny cross member does not line up with the mounting bolts. The C4 seems to be shorter or something. Is this normal or had I done something wrong?
 

·
Registered
Joined
·
46,010 Posts
That's normal, the C4 is shorter than the AODE you had. Most converting to the C4 had to modify the mount to get it to fit. I'd also make sure of the driveshaft length to be safe.
 

·
Registered
Joined
·
50 Posts
Discussion Starter · #3 ·
That's normal, the C4 is shorter than the AODE you had. Most converting to the C4 had to modify the mount to get it to fit. I'd also make sure of the driveshaft length to be safe.
Thanks, one other thing do you think that plate between the motor and the tranny is important (backing plate I think)? I just noticed we forgot to put it on?
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top