Ford Mustang Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
57 Posts
Discussion Starter #1
So I just installed my firewall adjuster and clutch quadrant and noticed that there was no place to use the screws that fasten the firewall adjuster to the firewall. It's not loose or anything. I just dont know what I should do ?
 

·
Registered
Joined
·
165 Posts
The instructions with my Steeda adjuster didn't really say either. But from what I've gathered, you can just screw the adjuster (outer ring) to the firewall which keeps it from turning or spinning when you adjust the inner ring.
 

·
Premium Member
Joined
·
1,758 Posts
I have the Steeda adjuster, which came with two screws. The old cable was only held in by one screw. The supplied screws are self-tapping, so I was going to use both, but I couldn't get my drill in there with enough pressure to run it in. It is now being held in by one screw.
 
1 - 3 of 3 Posts
Top