Ford Mustang Forum banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
134 Posts
Discussion Starter #1
I just installed a v8 diff. However I don’t know what gears have on it. I know thanks to Skoyote how to find out, which I will do tomorrow. However I the car run strong and its spinning both wheels when I burn them, but when I make turns the car doesn’t turn as fast as I was specting, once I go straight the car accelerates very good. Now I have two questions 1: How the traction control button on the bottom of my dash is going to work?



In case it doesn’t have the 3.27 what should I do? Change them, or keep it, I really don’t want to harm and force my engine. Thanks in advance I really don’t know how to thank you for helping my out.
 

·
Registered
Joined
·
11,433 Posts
Rodstang01 said:
I just installed a v8 diff. However I don’t know what gears have on it. I know thanks to Skoyote how to find out, which I will do tomorrow. However I the car run strong and its spinning both wheels when I burn them, but when I make turns the car doesn’t turn as fast as I was specting, once I go straight the car accelerates very good. Now I have two questions 1: How the traction control button on the bottom of my dash is going to work?



In case it doesn’t have the 3.27 what should I do? Change them, or keep it, I really don’t want to harm and force my engine. Thanks in advance I really don’t know how to thank you for helping my out.
if you have traction control, the computer is slowing you down by limiting your wheelspin. Shut it off.

What does it do in turns?

Leave the gears in, and reprogram the computer . .. When the t-lok burns out, then you can decide to worry about the gears.
 

·
Registered
Joined
·
11,433 Posts
Did you ever get a dyno tune?
 

·
Registered
Joined
·
134 Posts
Discussion Starter #4
kscoyote said:
Did you ever get a dyno tune?
No not yet, but i want to do that next week. When i stop and make turns slows down, and then go fast. How the diablo can be use in this situation, i run the program yesterday and the same. If i reprogram my comp, will that erase all the info that already has. I mean because of the injectors u know how hard that was. How do i reprogram my comp? Thanks
 

·
Registered
Joined
·
11,433 Posts
Rodstang01 said:
No not yet, but i want to do that next week. When i stop and make turns slows down, and then go fast. How the diablo can be use in this situation, i run the program yesterday and the same. If i reprogram my comp, will that erase all the info that already has. I mean because of the injectors u know how hard that was. How do i reprogram my comp? Thanks
I'm guessing there's a lag in the airflow . .. the DynoTune should clear that up.

It shouldn't erase what you've got. Use the DiabloSport programmer . . . Wait, did you ge tthe programmer or the chip?

If you're going for a dynotune, then don't worry about it .. .
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top