Ford Mustang Forum banner
Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
505 Posts
Discussion Starter · #1 ·
hey guys if i did tf twisted wedge heads what rockers and pushrods should i get? i wanna do roller rockers, and pushrods i dont really know what kind i should get on theses heads. Anyone know any rockers that would work with these heads? cams stock idk if that matters for clearence at all or not thanks guys!
 

·
Registered
Joined
·
505 Posts
Discussion Starter · #2 ·

·
Registered
Joined
·
6,319 Posts
the rockers will work,but the pushrods will most likely be too short..those are roughly stock size,from what ive seen most aftermarket alum heads generally require a longer than stock length PR..

you need to get a pushrod length checker and measure for YOUR MOTOR/COMBO..every one is different..nobody on the internet will be able to tell you the proper length needed for your combo..just cuz it works on their motor,doesnt mean it'll work for yours

pushrod length checker is like $15
 

·
Registered
Joined
·
13,079 Posts
Well never used those rockers but they can't be all that bad I would figure. I would call TFS and talk to them about it. I used the Comp gold rockers and just to give you an idea my pushrods were 6.7 so you will definitely need to measure them to be sure.
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top