Ford Mustang Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
In the middle of replacing the 4 vac lines on the tree. i have everything right except the "S/C" (speed control module) line. i know the actually module is the little plastic box to the left near my break peddle, but i cant figure where the line goes from the tree. helpp
 

·
Registered
Joined
·
590 Posts
What year? There is usually a unit in the fender on the drivers side, and the vacuum line goes to that unit. But that's on my 86, not sure where else they could have put it.
 

·
Registered
Joined
·
4,119 Posts
The S/C vacuum (should have a brown stripe if it's original) line goes from the large vacuum T into the drivers fender where it attaches to the servo from that point it goes back inside the cabin to the dump valve.
 
1 - 3 of 3 Posts
Top