Ford Mustang Forum banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
I am considering putting an M90 on my 2000 gt. I was just wondering where I can get the saleen intake manifold for the supercharger.
 

·
Registered
Joined
·
29 Posts
Hopefully your not going to put an m90 on your car jsut a little heads up the cobras run the m112. in all honest just go with some cobra heads and intake manifolds and run the m112 will be much happier. the m90 is what the 3.8L Thunderbirds ran on them.
 

·
Registered
Joined
·
9 Posts
Discussion Starter #3
Well the m90 also went onto the saleen so it was ok of it but I would rather have the m112. Would the cobra heads bolt to my block? I am looking for an inexpensive supercharger setup so give me some choices. And if anyone does know where to get the saleen intake manifold that would be cool too.
 

·
Registered
Joined
·
2,579 Posts
hawks05 said:
Hopefully your not going to put an m90 on your car jsut a little heads up the cobras run the m112. in all honest just go with some cobra heads and intake manifolds and run the m112 will be much happier. the m90 is what the 3.8L Thunderbirds ran on them.
You can't just bolt Cobra heads on a GT block without changing a hundred other things. If you don't have a clue as to what you are talking about, then don't give advice.
 

·
Registered
Joined
·
2,579 Posts
00gt said:
Well the m90 also went onto the saleen so it was ok of it but I would rather have the m112. Would the cobra heads bolt to my block? I am looking for an inexpensive supercharger setup so give me some choices. And if anyone does know where to get the saleen intake manifold that would be cool too.
You may be able to get one directly from Saleen. I wouldn't buy the supercharger unless the intake manifold came with it.
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top