Ford Mustang Forum banner
Status
Not open for further replies.
1 - 6 of 6 Posts

·
Registered
Joined
·
418 Posts
Discussion Starter · #1 ·
Will a 1972 351 bell housing (#D1TA-6394-AA) fit a 1972 302 block? Additionally, will that bell housing work with flywheel #C5AE-6380-E?
 

·
Registered
Joined
·
39 Posts
JPM, i am not fimiliar with the casting numbers but 351C and 351W both will fit a 302. not sure on the flywheel.
 

·
Registered
Joined
·
1,806 Posts
You have to use the 164 tooth flywheel with the larger bell housing. The block plate is also different so use the 351 plate. They position the starter differently so it will line up with the larger flywheel. The same starter will work as long as the flywheel has the same back spacing.
 

·
Registered
Joined
·
418 Posts
Discussion Starter · #4 ·
OK, great! I know that I need to match the flywheel and bell housing sizes but I wasn't sure if you could put a 164 tooth set from a 351c onto a 302. This bell is from a 1972 351c (larger style) and the flywheel is a 164 tooth. So I guess it will work. Thanks for the information.

Does anyone have any ideas where to find a used bell housing backing plate for the larger style bells?
 

·
Registered
Joined
·
1,806 Posts
Look in the wrecking yards on light trucks and vans.
 

·
Registered
Joined
·
418 Posts
Discussion Starter · #6 ·
Sounds like a plan. Thanks Paul
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top