Ford Mustang Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
29 Posts
Discussion Starter · #1 ·
i had a problem my passenger window would not roll up or down from the drivers side. so i thought i had broken wire between the two doors well i read for power and good grounds and it had it so i thought the switch. i swapped and proved it was the switch. (driver and passenger door switches are the same) so i got to looking online and they run from $14-$40 each. but i got to looking at the switch and its just held on by little tabs so lifted off and its got points. lol well i cleaned up the points with a emry board and bent the tabs a little and works like a new switch just wanted to let everyone else in so they wont have to waste money on a new switch when you can just clean yours:bigthumbsup
 

·
Registered
Joined
·
143 Posts
I did this myself yesterday.
The tiny points were Arced and Carboned, i used a very fine, tiny, folded piece of emery paper, and contact cleaner.
The Master switches (Drivers Door) were worse then the passenger side.

I get A LOT less hesitation when hitting the buttons now.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top